Versions Compared

Old Version 9

changes.mady.by.user Snow Li

Saved on

compared with

New Version Current

changes.mady.by.user Wall-E

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

In Origin9.1, we also support adding axis breaks to 3D plot axis.

Image RemovedImage Added

How to: 

  1. Double click the axis you want to add breaks on to open Axis Dialog.
  2. Go to X Axis/Y Axis/Z Axis: Breaks, check Enable checkbox.
  3. Set Number of Breaks. Origin support up to 7 breaks on one single axis.
  4. Specify each breaks's details in sub-nodes.

Show Axis in Both Side

 

Image RemovedImage Added

Image RemovedImage Added
  

How to:

Double click the axis you want to edit to open Axis Dialog.

  • Use Only One Axis For Each Direction checkbox on the top of the dialog.
    By defualt only one axis shows in each direction. Uncheck it, extra controls for each axis will show.
    Image RemovedImage Added
  • Show Axis dropdown list on X Axis/Y Axis/Z Axis page
    If Use Only One Axis For Each Direction checkbox is checked, user can go toX Axis/Y Axis/Z Axis page, and specify the position of axis in Show Axis dropdown list.
    E.g. user can specify Z axis to show on the right size instead of the left size.
  • Rotate dropdown list on X Axis/Y Axis/Z Axis page to control ticks, tick labe labels and title display
    This has higher priority than Plot Details: Layer Properties: Axis: Orientation of Labels & Titles & Ticks.
    Image RemovedImage Added